Color steel equipment will inevitably have such problems in the production process. The most common problem is the deviation of the color steel plate. Once the deviation occurs, it will affect the production efficiency of the machine and the product qualification rate. Therefore, we must know how to Correcting these mistakes, after a long period of research and exploration, we have come up with ways to adjust this problem: If the equipment board runs to the right, you need to use the iron block to the left corner, or the right side of the roller, the first few axes will flatten the first axis, the upper roller should be below the roll The shafts are consistent. If the top is flattened, the bottom should also be flattened. The uniformly symmetrical rollers cannot be changed. If it still doesn’t work, first adjust the four corners of the front and rear rows of the color steel tile presser from the big frame to the height of the upper end of the shaft, and then find a line from the first row to the last row. Straighten, check if the lower shaft is on a horizontal line, and adjust the left and right sides of the lower shaft to level. Find the symmetry point in the first row and the last row of the color steel equipment, and then fasten the locks on both sides, pull a straight line in front of and behind the center of the middle runner, and adjust the gap between the upper and lower shafts. Adjust the machine along the line. In fact, the remedy for the deviation of the board is that we need to produce and test it for a long time. Different directions of reversal have different remedies, but one thing to note is that both the mechanical roller and other parts need to be aligned on both sides, only two sides. Alignment can maintain symmetry, and the shape of the product will be regular.
The color steel equipment can also be called roll-type cold-bending forming, that is, in a row of tandem forming mills, the metal plate and the metal strip are connected in series, and then the plate is processed into a plastic working process of a desired cross-sectional shape. law. Roll cold forming (color steel tile equipment) has been used in bicycle rims, umbrella frame manufacturing and so on.
Quanlong Machinery is a Manufacturer and Supplier in China,and specialized in providing you with color steel equipment.
Commissioning of color steel equipment：
1. First, the heights of the front and rear lines of the color steel machine are the same from the upper end of the big frame to the upper end of the shaft. Then, from the first row to the last row, find a line straightened, check if the lower shaft is in On a straight line, adjust the left and right sides of the lower axis to level.
2. Find the center of the first row and the last row of the color steel equipment, then tighten the locks on both sides, pull a straight line in front of and behind the center of the middle wheel, and adjust the gap between the upper and lower shafts. The machine can be adjusted in a straight line.
3. The debugging method for the deviation of the platen of the color steel equipment, such as the plate running to the right, the left corner of the pad (feeding frame), or the bottom of the right side of the plate (the first few axes run off the bottom of the shaft, the upper shaft falls with the bottom axis).
