Roll forming machine will inevitably have such problems in the production process. The most common problem is the deviation of the roll forming machine. Once the deviation occurs, it will affect the production efficiency of the machine and the product qualification rate. Therefore, we must know how to Correcting these mistakes, after a long period of research and exploration, we have come up with a way to adjust this problem: if the roll forming machine runs to the right, you need to use the iron block to the left corner, or the right side of the roller Flat, the first few axes are flattened to flatten the first few axes. The upper roller should be consistent with the lower roller. If the upper surface is flattened, the lower one should also be flattened. The uniformly symmetrical roller cannot be changed. If it is not enough, first adjust the four corners of the front and rear rows of the roll forming machine from the large frame to the position of the upper end of the shaft, and then find a line straight from the first row to the last row. Check if the lower shaft is on a horizontal line and adjust the left and right sides of the lower shaft to level.
In the first row and the last row of the roll forming machine, find the symmetry point, then tighten the locks on both sides, pull a straight line in front of and behind the center of the middle runner, and adjust the gap between the upper and lower shafts. The machine can be adjusted in a straight line. In fact, the remedy for the deviation of the board is that we need to produce and test it for a long time. Different directions of reversal have different remedies, but one thing to note is that both the mechanical roller and other parts need to be aligned on both sides, only two sides. Alignment can maintain symmetry, and the shape of the product will be regular.
