Commissioning of color steel tile equipment:
1. First, the four corners of the front and rear queues of the color steel tile equipment are measured together from the height of the upper end of the large frame, and then from the first row to the final row, find a line straightened, check that the lower shaft is Instead of being on a straight line, turn the left and right ends of the lower axis to level.
2. Find the middle row and the final row of the color steel tile equipment, then tighten the two locks, pull a straight line in front of and behind the middle wheel, and adjust the gap between the upper and lower shafts. You can adjust the machine along the line.
3, color steel tile equipment – pressure tile machine plate deviation detection method, such as the plate to the right, pad left corner (feed frame), or the right side of the bottom flat (the first few axes run off the first few axes flat, on The axis falls with the bottom axis).
The color steel tile equipment layout is reasonable and convenient to operate, and the function is complete. The feeding, pressing, dripping, heating, trimming, slotting and blocking are made into plates. Color steel tile equipment is used for steel layout factory housing panels. Color steel tile equipment uses fine low-speed metering pump, frequency control, (or stepless speed regulation), computer control, accurate measurement. Color steel tile equipment can also be called roll-type cold-bending forming, that is, on a row of tandem forming mills, liaising through metal plates and metal strips, in turn, the color steel tile equipment uses fine low-speed metering pumps, frequency control, ( Or stepless speed regulation), computer control, accurate measurement.
The color steel tile equipment can also be called roll-type cold-bending forming, that is, in a row of tandem forming rolling mills, the metal sheets and the metal strips are contacted, and the sheets are bent to be sequentially processed into a plastic processing of a desired cross-sectional shape. The method of roll-type cold-bending forming (color steel tile equipment) has been used for bicycle rims, umbrella frame making, and the like.
