The high-altitude bulk method of the sandwich panel machine has two kinds of full brackets (ie full house scaffolding) and cantilever method. The full-support method is mostly used for assembling parts, while the cantilever method is mostly used for small units to fight at high altitude. Since the parts are assembled at high altitude, there is no need to use large lifting equipment, but a large amount of scaffolding material is required due to the large-scale assembling bracket.
The sandwich panel machine strip or block installation method strip or block installation method refers to the grid rack or block unit is respectively hoisted by the lifting equipment to the high-altitude design position in place, and then the overall installation method .
The strip shape is divided into several sections along the long span of the grid, and the width of each section may be one grid to three grids, and the length thereof is the span of the short span of the grid. The block shape means that the shape of the unit divided in the longitudinal and lateral directions of the grid is a rectangle or a square. The weight of each unit of the sandwich panel machine is based on the lifting capacity of the existing lifting equipment on site.
Most of the welding and splicing work of the sandwich panel machine is carried out on the ground, which is beneficial to improve the quality of the project and save most of the assembled brackets. Since the splitting unit has already considered the existing lifting equipment capacity on site, it can make full use of the existing equipment on the site, and reduce the rental cost of the lifting equipment. The high-altitude bulk method of the sandwich panel machine refers to the small unit or the parts ( Single bar and single node) The method of total spelling directly at the design location.
