In the process of production, it is inevitable that such or such problems will occur in the colored steel equipment. The most common problem is the deviation of colored steel plates. Once there is a deviation, it will affect the production of machinery, causing the engineering to lag behind and the installation can not be implemented. So we have to know how to correct these mistakes. After a long period of research and exploration, we have come up with a way to adjust this problem: If the device board runs to the right, you need to use iron blocks to the left corner, or to flatten the right roller. The first few axis runs to flatten the first few axes. The upper roller should be consistent with the lower roller. If the upper roller is flattened, the lower roller should also be flattened. The uniform and symmetrical roller can not be changed.
If not, first adjust the four corners of the front and back rows of the colored steel tile equipment from the big frame to the height of the upper end of the axis, and then from the first row to the last row, find a line to straighten. Check to see if the lower shaft is on a horizontal line. Set the left and right sides of the lower shaft horizontally. The first row and the last row of the colored steel equipment find the symmetry point, and then tighten the two sides to lock the mother, pull a straight line in front of the main center of the middle wheel, and adjust the gap between the upper and lower axes., you can adjust the machine along the line. In fact, the remedy for plate deviation needs to be produced and tested for a long time. There are different remedies for different deviation directions, but one thing to note is that whether it is a mechanical roller or other parts need to be aligned on both sides. Only the alignment of the two sides can maintain symmetry, and the shape of the product production will be regular.