You are here: Home » Blog » How can the Roll Forming Machine not Go Wrong?

How can the Roll Forming Machine not Go Wrong?

Time:2018-09-23

Find the center of the first row and the last row of the Roll Forming Machine, and the global PCB industry presents a growth trend review, then tighten the locks on both sides, and pull a straight line in front of and behind the center of the middle wheel to turn up and down. After the clearance of the shaft is adjusted, the machine and the valve can be adjusted along the straight line; the four corners of the front and rear lines of the Roll Forming Machine are the same from the upper end of the big frame to the upper end, and then from the first row to the last row. Find a line straight, check if the lower shaft is in a straight line, and adjust the left and right sides of the lower shaft to level.

Roll Forming Machine

C-shaped steel machine; Roll Forming Machine – the method of debugging the pressure plate of the pressing machine, such as the board running to the right, the left corner of the pad (feeding frame), or the bottom right side of the flat (the first few axes run off the first axis) The upper shaft falls with the bottom shaft. Straightening of the bending or twisting of the color steel equipment is usually carried out between the last forming roll and the cutting die. If the last roll cannot effectively support the profile, then one of the straightening mechanisms is entered. On the side, the entire profile section must be supported, while for asymmetry straightening, torsional deformation may occur at the same time as straightening, in which case bending and torsion straightening are required in the opposite direction of the profile deformation. When straightening the profile of color steel forming equipment, it does not need to be in full contact with the surface of the profile and the straightening mechanism. However, in the part where the profile is bent and deformed, the contact with the straightening mechanism is very important, in order to avoid deformation of the profile. The arc radius of the contour of the straightening mechanism should match the arc of the section of the profile.


Copyright 2018 © Zhangjiagang City Quanlong Machinery co., ltd.